EPRO MMS6120 - Image 1
EPRO MMS6120 - Image 2
Click to enlarge
EPRO MMS6120
EPRO MMS6120 - Image 2
Kollmorgen MMC-SD-0.5-230-D
Kollmorgen MMC-SD-0.5-230-D
Back to products
EPRO MMS3125/022-020
EPRO MMS3125/022-020

EPRO MMS6120

  • Product Name: MMS6000 Series Dual Channel Bearing Vibration Monitor
  • Product Introduction: A 3U plug-in module for online condition monitoring and protection of turbine/compressor bearing housing absolute vibration (case vibration), compliant with API 670.
Category:
Description
  • Technical Specifications & Performance Parameters:
    • Channels: 2 independent inputs
    • Inputs: Compatible with PR9266/PR9268 velocity sensors (-5V to +15V DC diff)
    • Frequency Range: 10 Hz – 1 kHz (velocity), 10 Hz – 10 kHz (acceleration)
    • Measurement Values: VRMS (mm/s), Spp (µm displacement)
    • ADC Resolution: 16-bit
    • Outputs: 2 x 4–20 mA (load ≤500Ω), 2 x 0–10V, Buffered dynamic outputs
    • Power: 24 V DC redundant
    • Accuracy: ±2% FS
  • Functional Features: Programmable Alert/Danger relays per channel; Keyphasor input for order tracking; Hot-swappable in MMS6010 rack; Self-diagnostic OK system.
  • Material & Structural Characteristics: 3U Eurocard PCB with front panel LEDs and test points; Rear backplane connector for rack power/bus; Shielded input conditioning circuits.
  • Working Principle: Conditions sensor signal (amplify, filter, integrate/differentiate), digitizes via ADC, computes RMS/Peak values, compares against setpoints, and drives relays or analog transmitters.
  • Installation Requirements: Insert into EPRO MMS6000 rack slot; Shielded twisted pair for sensor wiring grounded at one end; Terminate 4–20mA loops with correct burden resistor.
  • Usage Precautions: Sensor calibration constants must match module config; Avoid ground loops by proper cable shielding; Do not remove under live vibration if rack lacks hot-swap confirmation.
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “EPRO MMS6120”

Your email address will not be published. Required fields are marked *

Shipping and Delivery
wd-ship-1
wd-ship-2

MAECENAS IACULIS

Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.

ADIPISCING CONVALLIS BULUM

  • Vestibulum penatibus nunc dui adipiscing convallis bulum parturient suspendisse.
  • Abitur parturient praesent lectus quam a natoque adipiscing a vestibulum hendre.
  • Diam parturient dictumst parturient scelerisque nibh lectus.

Scelerisque adipiscing bibendum sem vestibulum et in a a a purus lectus faucibus lobortis tincidunt purus lectus nisl class eros.Condimentum a et ullamcorper dictumst mus et tristique elementum nam inceptos hac parturient scelerisque vestibulum amet elit ut volutpat.

Related products

CONTROL 9180B-8

  • Power Supply: Supports AC 220V/50Hz or DC 24V, depending on design requirements.
  • Communication Interfaces: Equipped with RS-485, Ethernet, and Modbus protocols for seamless integration with other devices or systems.
  • Processor: High-performance CPU ensures rapid response and accurate control.
  • Protection Rating: IP65 or higher for dust and water resistance, suitable for harsh industrial conditions.
  • Operating Temperature: Wide temperature range to adapt to diverse industrial settings.
Read more
Quick view

Elmo G-TUB30480ERSS0

  • Rated Voltage: 480 VAC
  • Rated Current: 30 A
  • Continuous Power: Up to 25 kW
  • Communication Interfaces: Ethernet, CANopen, RS232, EtherCAT, etc.
  • Feedback Types: Encoder, resolver, Hall sensor (depending on the model)
  • Operating Temperature Range: - 40°C to +70°C (industrial - grade)
  • Protection Level: IP20 or higher (depending on the model)
  • Installation Method: Rack - mount, DIN - rail mount (depending on the model)
Read more
Quick view

KEBA FB201 — Comprehensive Data Sheet

Procurement Guidance

  1. Compatibility Notes
    • Verify suffix codes (e.g., FB201/xxx) for I/O capacity and environmental ratings .
    • Requires KEBA RobotStudio or ECL-3 software for configuration .
  2. Critical Accessories
    • Backplane Adapter (e.g., SDCS-PIN-24) for PLC integration .
    • IP65 Housing for harsh environments (e.g., oil rigs, substations) .
  3. Avoid Mismatches
    • Servo drives → Refer to KEBA KeDrive.
    • HMIs → Use KEBA ETT Series.
Read more
Quick view

KONGSBERG MRU-E-JB3

Technical Specifications:
  • Measurement Axes: 6 DOF (Degrees of Freedom) - heave, surge, sway, roll, pitch, and yaw
  • Accuracy: High accuracy across all axes with minimal latency
  • Update Rate: Configurable up to 100 Hz for real-time applications
  • Operating Voltage: Typically 12 to 36 VDC
  • Power Consumption: Low power consumption suitable for extended operation
  • Operating Temperature: -40°C to +70°C, ensuring performance in extreme environments
  • Storage Temperature: -50°C to +85°C
  • Humidity Range: 0% to 100% relative humidity, waterproof design
  • Environmental Protection: IP68 rated for underwater use and protection against dust and water ingress
  • Communication Interfaces: RS-232, RS-422, Ethernet, NMEA 0183, and others depending on configuration
Read more
Quick view

Motorola IPMC761-002

  • Processor: Equipped with an MPC7450 series PowerPC processor at 1 GHz, with 512 KB of on - chip L2 cache and 2 MB of L3 cache, and an Altivec coprocessor for high - performance computational applications.
  • Memory: Two banks of soldered flash memory.
  • Communication Interfaces: Includes 1 parallel port, 2 asynchronous serial ports, and 2 synchronous/asynchronous serial ports.
  • Bus Type: VME bus.
  • Power Supply: Draws +5 V and +3.3 V through the PMC connectors.
  • Dimensions: 263 × 58 × 28 mm.
  • Weight: 4.3 kg.
Read more
Quick view

NOUENVOG AAP3798102-00131

Application Scenarios

  1. Compressor Control Systems
    • Cameron TA-Series: Manages inlet valve positioning, oil pressure, and vibration monitoring in TA2000/TA3000 compressors .
  2. Energy Infrastructure
    • Pump Stations: Regulates flow/pressure in pipeline transport .
    • Gas Turbine Backup: Synchronizes auxiliary systems during grid failures .
  3. Industrial Automation
    • Production Lines: Interfaces with Schneider/Bently Nevada PLCs for safety interlocks .
    • Remote Monitoring: Transmits operational data to SCADA via Modbus .
Read more
Quick view

XP POWER F8B6D4A3G3

Technical Specifications

  • Output Characteristics: It is a quad - output power supply, but specific output voltage and current values are not clearly provided in the existing information.
  • Dimensions: Approximately 15 × 11 × 7 inches (LxWxH).
  • Weight: About 8 lbs.
Read more
Quick view

Yaskawa CACR-SR07BE12M

  • Input Voltage: Three - phase AC 200V - 230V
  • Output Current: 7A
  • Output Power: 1.5kW or 0.75kW
  • Control Method: Vector control
  • Communication Interface: RS - 485
  • Protection Level: IP20
  • Output Frequency Range: 0.1 - 400Hz
  • Overload Capacity: 150% of the rated current for 60 seconds
  • Dimensions: 150mm * 240mm * 350mm
  • Weight: Approximately 1.14kg
Read more
Quick view