Emerson DeltaV KJ3243X1-BA1 - Image 1
Emerson DeltaV KJ3243X1-BA1 - Image 2
Click to enlarge
Emerson DeltaV KJ3243X1-BA1
Emerson DeltaV KJ3243X1-BA1 - Image 2
Emerson DeltaV KJ3223X1-BA1
Emerson DeltaV KJ3223X1-BA1
Back to products
Emerson DeltaV KJ4001X1-CE1
Emerson DeltaV KJ4001X1-CE1

Emerson DeltaV KJ3243X1-BA1

Product Name:​ Emerson DeltaV KJ3243X1-BA1 Series 2 Profibus DP (Distributed Peripheral) Communication Card
Product Introduction:​
The KJ3243X1-BA1 is a DeltaV Series 2 local bus communication interface card that enables the DeltaV controller to communicate with Profibus DP slave devices (e.g., remote I/O, variable frequency drives, smart actuators) via an RS-485 network.
Category:
Description
Technical Specifications:
  • Manufacturer:​ Emerson Automation Solutions
  • Model / Part No.:​ KJ3243X1-BA1
  • Series:​ DeltaV Series 2
  • Function:​ Profibus DP-V0/V1 Master Interface
  • Interface Port:​ DB9 female (RS-485), optically isolated
  • Protocol:​ Profibus DP per IEC 61158/61784
  • Baud Rate:​ 9.6 kbps to 12 Mbps (auto-negotiated with slaves)
  • Number of Slaves Supported:​ Up to 125 addresses (practical limit depends on controller load)
  • LocalBus Power:​ 12 V DC, 150 mA typical
  • Field Power (if applicable):​ Not powered from this card; Profibus segment requires its own terminator and bias power
  • Connectors:​ One Profibus DP port; one service port (sometimes present)
  • Diagnostics LEDs:​ PWR, COM, ERR, RUN
  • Hot-Swap:​ Yes (with controller redundancy supported)
  • Operating Temp:​ -20 °C to +60 °C
  • Certification:​ CE, FM, CSA, C-Tick; Class I Div 2
  • Weight:​ ~0.18 kg
Functional Features:
  • Full GSD file import into DeltaV for slave configuration
  • Cyclic data exchange and acyclic parameter access (DP-V1)
  • Built-in segment diagnostics (telegram loss, slave failure)
  • Redundant media optional with external repeater
Installation Notes:
  • Install in dedicated communication slot of DeltaV controller or I/O carrier (per system architecture)
  • Use Profibus-approved shielded twisted pair (A/B lines), proper termination at both ends of segment
  • Set node address via DIP switches or software (usually 1–126)
  • Keep Profibus cable away from high-voltage/high-current conductors
Applications:​ Integration of Siemens/third-party remote I/O racks, ABB/Fuji/Vacon/Siemens drives with Profibus DP interface, intelligent motor starters, weighing systems into Emerson DeltaV DCS.
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Emerson DeltaV KJ3243X1-BA1”

Your email address will not be published. Required fields are marked *

Shipping and Delivery
wd-ship-1
wd-ship-2

MAECENAS IACULIS

Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.

ADIPISCING CONVALLIS BULUM

  • Vestibulum penatibus nunc dui adipiscing convallis bulum parturient suspendisse.
  • Abitur parturient praesent lectus quam a natoque adipiscing a vestibulum hendre.
  • Diam parturient dictumst parturient scelerisque nibh lectus.

Scelerisque adipiscing bibendum sem vestibulum et in a a a purus lectus faucibus lobortis tincidunt purus lectus nisl class eros.Condimentum a et ullamcorper dictumst mus et tristique elementum nam inceptos hac parturient scelerisque vestibulum amet elit ut volutpat.

Related products

Emerson 1X00569H01

Product Description: The 1X00569H01 is a 16-channel digital input module for the Ovation DCS. It accepts 24 VDC discrete signals from field devices including pushbuttons, limit switches, relay contacts, and proximity sensors. The module provides galvanic isolation on every channel and supports debounce filtering for noise immunity.
Read more
Quick view

EMERSON 38B5786X132 Pneumatic Relay

Technical Specifications:
  • Action Principle: Utilizes gas pressure variations to trigger mechanical switching (e.g., opening/closing circuits).
  • Pressure Range: Operates within standard industrial pneumatic pressure thresholds (specific values depend on configuration).
  • Response Time: Rapid actuation due to gas flow dynamics, typically milliseconds-scale.
  • Environmental Tolerance:
    • Temperature: -40°C to +85°C (storage and operation).
    • Protection Grade: IP30 (dust and water resistance).
  • Mechanical Durability: Robust design withstands vibration, shock, and corrosive gases.
  • Dimensions: Approximately 25 × 32 × 65 mm (varies by mounting type).
  • Weight: Around 2.3 kg.
Read more
Quick view

EMERSON A6210 Thrust Position, Differential Expansion, and Rod Position Monitor

Technical Specifications:
  • Form Factor: Dual-channel, 3U-sized, single-slot plug-in module (reduces cabinet space by 50% compared to traditional 6U cards).
  • Standards Compliance: Meets API 670 and API 618 requirements for mechanical protection and thermal expansion monitoring.
  • Output Signals:
    • 0/4-20 mA current output
    • 0-10 V voltage output
    • Proportional output for system integration.
  • Self-Diagnostic Functions:
    • Hardware monitoring
    • Power input verification
    • Temperature monitoring
    • Sensor and cable integrity checks.
Read more
Quick view

EMERSON A6500-CC9199-00120 Advanced Protection and Monitoring Module

Technical Specifications:
  • Form Factor: 3U rack-mountable module with dual-channel capability.
  • Channels: Supports up to 16 input channels for vibration, temperature, and process variables.
  • Sampling Rate: Up to 100 kHz per channel for high-resolution data capture.
  • Frequency Range: 0.1 Hz to 20 kHz (adjustable based on application).
  • Standards Compliance: Meets API 670, API 618, and ISO 10816 for machinery protection and vibration analysis.
  • Output Signals:
    • 4-20 mA current loops
    • Relay outputs (alarm/trip)
    • Ethernet/Modbus communication for system integration.
Read more
Quick view

EMERSON Liebert 805411 Precision Cooling Controller

Technical Specifications:
  • Control Capacity: Supports group control of up to 32 air conditioning units, with flexible grouping for backup, rotation, and load balancing.
  • Communication Interfaces:
    • RS485/Modbus RTU for integration with building management systems (BMS).
    • Ethernet for remote monitoring and configuration.
  • Input/Output Signals:
    • Analog inputs for temperature/humidity sensors.
    • Digital outputs for alarm and status indicators.
    • Relay outputs for compressor/fan control.
  • Display: LCD screen with multi-language support for real-time parameter visualization.
  • Power Supply: 24V AC/DC with redundancy options.
Read more
Quick view

EMERSON PR6426/010-140 + CON021/916-200 – Eddy-Current Vibration & Displacement System

The Emerson PR6426010-140 in conjunction with CON021916-200 appears to be part of Emerson's range of measurement and control devices, specifically designed for pressure measurement in industrial applications. These components are often associated with Rosemount, a brand well-known for its high-quality pressure transmitters and other instrumentation devices used across various industries.
Read more
Quick view

EMERSON VE3008 CE3008 KJ2005X1-MQ1 12P6381X042 – DeltaV MQ Controller

Technical Specifications:

  • Device Type: Digital Valve Controller / Positioner
  • Model Series: VE3008 and CE3008 are part of the same product family, with VE3008 typically representing the electronic control module and CE3008 indicating the complete positioner assembly.
  • Actuator Compatibility: Designed to work with pneumatic actuators, providing precise control over valve position.
  • Communication Protocols: Supports HART, FOUNDATION Fieldbus, and other digital communication standards for integration into control systems.
Read more
Quick view

MERSON 1X00781H01L Power Module

Technical Specifications:
  • Input Voltage: 100-240 VAC (47-63 Hz)
  • Output Voltage: 24 VDC
  • Rated Output Current: 10 A
  • Output Ripple & Noise: <50 mVpp
  • Efficiency: >85%
  • Operating Temperature Range: -40°C to +70°C
  • Storage Temperature Range: -40°C to +85°C
  • Protection Grade: IP30
  • Installation: DIN rail mounting
  • Dimensions: 100 × 58 × 25 mm
  • Weight: 350 g
Read more
Quick view